How to make our project?
Prototype Type “Materials List”
Prototype Type “Cut List”
QTY
DIMENSIONS
2(front & back)
30'' x 4'' x ½'' (plywood)
2(sides)
17'' x 4'' x ½''
1(top)
30'' x 18'' x ½'' (plywood)
1(circle)
10'' x 10'' x ½'' (PVC piping)
2(top)
1'9'' x 10' x ½'' (plywood)
1(circle dividers)
1'3'' x 10'' x ¼'' (plastic)
Prototype Type “Build Plan”
Front & Back
- Plywood
- Large PVC piping (plastic)
- Wooden knob
- Wooden legs
- Light bulb
- Button
- Circuits
Prototype Type “Cut List”
QTY
DIMENSIONS
2(front & back)
30'' x 4'' x ½'' (plywood)
2(sides)
17'' x 4'' x ½''
1(top)
30'' x 18'' x ½'' (plywood)
1(circle)
10'' x 10'' x ½'' (PVC piping)
2(top)
1'9'' x 10' x ½'' (plywood)
1(circle dividers)
1'3'' x 10'' x ¼'' (plastic)
Prototype Type “Build Plan”
- Gather materials
- Cut them according to the cut list
Front & Back
- Take plywood
- Start with the front, and back (the larger cuts)
- Then cut out the legs
- Do the same on both front and back
- The legs will be at default size 2'' x 3''
- Then make them fit snug in the inner side of the table (by either glue, nails, etc)
- cut them according to the cut list
- Then glue them to the inner side of the front and backs (one at a time)
- Wait to dry over night while being supported
- Do the same to the other side
- With this section you will be attaching wood to support the circuit and light bulb
- It will go roughly in the center
- You are going to take the 10''x10'' PVC piping
- Attach a metal rod from the bottom through the center of the PVC piping (make sure that its sturdy
- Then attach the plastic partitions (by either glue, nails, etc) to/through the metal rod
- With each partition there will be a specific setting, follow the drawing in order to know what to put in each one, with there specific layers, etc.
- Make the wooden knob (or purchase one)
- Attach it to the top part of the cylinder